Leadshine Ma860-Hstepper Motor for CNC Router

Ma860H driver

MA860H – 2 Phase Analog Stepper Drive Max 80 VAC or 110 VDC / 7.2A

one. Extremely cost-efficient

2. Good high speed performance

3. Supply voltage up to 80VAC or +110VDC

four. Output current up to 7.2A

5. Self-adjustment technology

six. Pure-sinusoidal current control technology

7. Pulse input frequency up to 300 KHz

8. TTL compatible and optically isolated input

nine. Automatic idle-current reduction

10. 16 selectable resolutions in decimal and binary, up to 51,200 steps/rev

11. Suitable for 2-phase and 4-phase motors

twelve. Support PUL/DIR and CW/CCW modes

thirteen. Short-voltage, over-voltage, over-current and short-cicuit protection

 

 Description 

 

The MA860H is a high performance microstepping drive based on pure-sinusoidal current control technology. Owing to the above technology and the self-adjustment technology (self-adjust current control parameters) according to different motors, the driven motors can run with smaller noise, lower heating, smoother movement and have better performances at higher speed than most of the drives on the markets. It is suitable for driving 2-phase and 4-phase hybrid stepping motors.

 

 

 CZPTal Specifications 

 

Parameters

MA860H

Min

Standard

Max

Device

Output current

1.eight

seven.2 (five.1 RMS)

A

Supply voltage

36

48

eighty

VAC

+fifty

+sixty eight

+110

VDC

Logic signal current

7

10

16

mA

Pulse input frequency

300

KHz

Isolation resistance

five hundred

 

 

MO

 

 

The default axle diameter of 86HS35 is 9.five, the default cease port is seventy three, optional 60

 

The default axle diameter of 86HS45 is 12.7, which is optional 14. The cease port is 73, which is optional 60.

 

The default axle diameter of 86HS65 is twelve.seven, which is optional fourteen. The quit port is 73, which is optional 60.

 

The default axle diameter of 86HS85 is twelve.seven, which is optional fourteen. The end port is seventy three, which is optional sixty.

 

The default axle diameter of 86HS120 is fifteen.875, the default quit port is seventy three, optional 60

Leadshine Ma860-Hstepper Motor for CNC Router